335春晨YCBP扁电缆

江苏春晨电缆有限公司生产YCBP扁电缆，春晨YCBP扁电缆，*YCBP扁电缆，HGGP2 high temperature silicone ru*er cable with silicone ru*er insulation or sheath material, silicon ru*er itself has high temperature resistant, cold resistant, soft, wear-resistant and anti-corrosion properties, so the cable under the environme*f high temperature stable electrical performance, good ageing resistance, long service life, [details]
HGGP2 high temperature silicone ru*er cable applicati*: suitable for AC 1KV and below with tensile strength, heat resistance, anti-corrosion and other special requirements of the crane, trolley, tran*ission machinery and other mobile devices and electric power tran*ission line and co*ol, lighting, communication lines, this product has been widely used in metallurgy, electric power, chemical industry, shipbuilding, port etc..
HGGP2 high temperature silicon ru*er cable producti*tanda*: the use of enterprise standa*
HGGPHGGP2 high temperature silicon ru*er cable technical parameters:
1, the finished cable conductor DC resistance: 20 degrees should meet the requirements of GB/T3956, the DC resistance of finished cable core wire, conversio*the cable length is 1m, the nominal cross section is 1mm2 and the temperature is 20 degrees centigrade, copper wire core should be less than 0.0184.
The insulation resistance of insulated conductors 2, finished cable line core insulation: insulation resistance of the finished cable, conversio*the cable length is 1km and the temperature is 20 degrees centigrade, the conductive wire core section in 50mm2 and the following should be no less than 50M ohm, 70~185mm2 should not be less than 35M.
3, the finished cable should be subjected to power frequency AC test, voltage 3000V and 5min voltage test, insulation without breakdown.
HGGP2 high temperature silicone ru*er cable characteristics
1 、 rated voltage UO/U:600/1000V.
2 、 the allowable working temperature range of cable is -60 DEG C to +180 centigrade.
3 the maximum temperature of the cable conductor shall not exceed 250 DEG C during the short circuit (the longest duration is not more than 5S).
4, the cable laying temperature should be no less than -20 degrees centigrade.
5. The bending radius of the cable is as follows: the bending radius of the single core cable is not less than 15D of the outer diameter of the cable; (the outer diameter of the D- cable)